PowerLite Pro G5200WNL Projector

Selected FAQ

Q:
What should I do if I see static or noise in the image?
A:
Check the following:

  • If you’re using a computer cable longer than 6 feet (1.8 meters), or an extension cable, the image quality may be reduced.


  • Keep your computer and video cables separated from the power cord as much as possible to prevent interference.


  • If you’re using an extension cable, you may pick up interference if the cable is not adequately shielded. You may need to use a signal amplifier for longer cables.


  • The video signal may be split between the computer and the projector. If you notice a decline in the projected image quality when the image is displayed simultaneously on your laptop computer and the projector, turn off the laptop’s LCD display.


  • Make sure the correct input signal is selected in the Signal menu. See Adjusting Signal Settings for details.


  • If you’re projecting from a composite video source, check the Video Signal setting in the Signal menu. In most cases, leave it set to Auto. If you’re using a 60-Hz PAL video source, change this setting to PAL60. See Adjusting Signal Settings.


  • If you’ve used the Quick Corner or Keystone adjustment, you may need to decrease the Sharpness setting in the Image menu. See Adjusting the Image for details.


  • Make sure the cables are securely connected at both ends.


  • Select the correct resolution. See Compatible Video Formats.


  • If you’re projecting from a computer, make sure its signal is compatible with the projector. See Compatible Video Formats.
Published: June 4, 2008

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page