Epson Stylus Pro GS6000

Selected FAQ

How do I cut off my prints?
Follow these steps to manually cut off your prints:
  1. Make sure READY appears on the LCD display.

  2. Press or to adjust the cutting position of the media, if necessary. (When you are using the Auto Take-Up Reel, you cannot feed the media backward.)

  3. Open the front cover.

  4. If you are not using the Auto Take-Up Reel, hold your print and pull slightly to remove any slack.

  5. Using a razor blade or other cutting tool, cut off your print by guiding the tool along the cutting groove in the post heater as shown.

  6. Warning: Do not place your fingers in the path of the cutting tool to avoid injuring yourself.

  7. If you are using the Auto Take-Up Reel, the scroller rotates to take up your printed media. To stop media take-up, set the switch on the top of the reel controller to OFF.

Published: September 15, 2008

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page