Epson Ensemble HD 720 Projector

Selected FAQ

I replaced the projection lamp, but I still see the message Replace the Lamp. How do I clear this message?
If you have access to the remote control that came with the projector (not the Ensemble HD remote), you can use it to reset the lamp usage timer, as described below.

Note: If you don’t have the remote control, you’ll need to remove the cover on the bottom of the projector enclosure (see Adjusting the Image Position and Focus) and then use the buttons on the projector’s control panel to access the Reset menu.

  1. Press the Menu button on the projector or the remote control that came with the projector.

  2. Use the menu navigation buttons to open the Reset menu, then select Reset Lamp Hours.

  3. When you see a confirmation prompt, highlight Yes and press the Select button.

  4. When you’re finished, press the Menu button to exit.
The lamp usage timer shows 0H until you’ve used the lamp for at least 10 hours.
Published: May 28, 2008

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page