Epson Ensemble HD 1080 Projector

Selected FAQ

Q:
How and when should I clean or replace the air filter?
A:
Your projector includes an air filter to ensure the best performance. If dust collects on the air filter on the bottom of the projector, clean it as described below. Dust prevents proper ventilation, causes overheating, and can damage the projector.

Warning: Before you clean any part of the Ensemble HD home theater system, turn off the system and unplug the power cord as described below.

Note: To clean the air filter, you will need a ladder that is tall enough for you to see over the top of the projector.
  1. Press the  Power button on the projector and wait for the  Power light to stop flashing. The projector cools down.


  2. Turn off the projector using the power switch on the back.




  3. Unplug the power cord.


  4. Use a small vacuum cleaner that is designed for computers and other office equipment to clean the filter on the bottom of the projector. If you don’t have one, gently clean the filter using a very soft brush (such as a clean artist’s paintbrush).

    If the dirt is difficult to remove or the filter is broken, replace it. You can purchase an air filter from your dealer or online at EnsembleHD (U.S. sales only).

    If you require assistance cleaning or replacing the air filter, contact your dealer or installer.


  5. If you need to replace the filter, release the tab and lift up the cover.




  6. Remove the old filter and replace it with a new one.





  7. To replace the cover, insert the tabs and press down until the cover clicks into place.


Published: September 25, 2008

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page