Epson WorkForce 600 All-in-One Printer

Selected FAQ

Q:
What should I do if my WorkForce 600 Series doesn't detect the photos placed on the scan bed when I use the Copy/Restore Photos option on the control panel?
A:
Check the following:
  • Make sure the scan bed glass is clean and free of finger prints, smudges, etc. (When cleaning the glass, spray the glass cleaner onto a cloth and then wipe the glass. Never spray glass cleaner directly onto the scan bed.)


  • Make sure the photos are placed on the scan bed correctly. See Place Originals for Copying, Scanning, or Faxing.


  • If you’re placing two photos on the scan bed, make sure they are not larger than 4 × 6 inches.


  • When copying two photos (up to 4 × 6 inches), place them 1/4 inch (5 mm) apart as shown below.

Published: August 29, 2008

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page