Epson MovieMate 55 Projector

Selected FAQ

No image appears. What should I do?
Check the following:

  • Make sure the projector is turned on (the   light is green and not flashing). If the   light is flashing green, wait for the projector to warm up.

  • Make sure the lens cover slide is open.

  • Make sure the region code on the DVD is ALL, 1, or labeled NTSC.

  • Check the  lamp warning light. If it is flashing orange or red, you need to replace the lamp. For instructions see Replacing the Lamp.

  • The Screensaver feature turns off the picture if a still image is projected for more than 30 minutes. See Saving Power for instructions on adjusting Sleep settings.

  • If you’re using an external video device, check the following:

    • Make sure the external video equipment is turned on, connected, and set up correctly.

    • Press the  button on the projector or the remote control.

    • Press the  or Play button on the connected video device.
Published: September 25, 2008

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page