Epson MovieMate 55 Projector

Selected FAQ

Q:
What should I do if the remote control does not work?
A:
Check the following:

  • Make sure the toggle switch is in the correct position: select -123 to use the numeric buttons, or Func.- to use the other functions of these buttons.


  • You may need to replace the remote control’s batteries. Make sure the positive (+) and negative (-) ends are positioned as shown in the battery compartment.


  • Some discs don’t support all of the remote control’s functions.


  • If you’re using a “universal” remote control, it might not work with the projector. Epson does not support any third-party remote controls.


  • Make sure you are within 19 feet of the projector, and within range of its front or back sensor (approximately 30 degrees left or right, and 15 degrees above or below).


  • Excessive light (including sunlight) can affect the remote control function. Try turning off the light or closing the blinds if sunlight is coming in the room.
Published: September 25, 2008

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page