PowerLite G5000 Projector

Selected FAQ

Q:
The remote control doesn’t work. What should I do?
A:
Check the following:

  • Point the remote control towards the receiver.


  • Make sure you are within 49 feet of the projector, and within range of the projector’s front or back sensor.


  • Make sure at least one of the projector’s remote receivers (front or rear) are turned on in the Settings menu. See Customizing Projector Features.


  • If any buttons on the remote control are held for more than 30 seconds, the remote enters sleep mode. Release any button that is held to wake the remote.


  • The remote control batteries may not be installed correctly or may be low on power. See Replacing the Batteries.


  • Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector’s infared receivers. Also, turn off any nearby equipment that emits infrared energy, such as a radiant room heater. If necessary, use the Remote Receiver setting to disable the projector’s front or back sensor if it continues to pick up interference. See Customizing Projector Features.


  • When the optional remote control cable is connected, the remote control light-emitting area and the projector’s remote receiver are disabled. If you’re not using the cable, make sure it is disconnected from both the remote control and the projector.


  • Make sure the Remote Receiver setting isn’t disabling both of the projector’s sensors. See Customizing Projector Features.


  • Make sure the projector and remote control IDs match. To operate all projectors by remote control regardless of ID settings, set the ID switch on the side of the remote control to Off.
Published: January 19, 2009

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page