Epson WorkForce 1100 Inkjet Printer

Selected FAQ

I replaced an ink cartridge and my printer still shows that ink is expended. What should I do?
If you have just installed a new cartridge and you still see an ink related error, the cartridge may not be installed correctly.

Follow the steps below to make sure the cartridge is correctly installed.

Note: We recommend that you use genuine Epson cartridges and do not refill them. The use of other products may affect your print quality and could result in printer damage.

  1. Make sure the printer is turned on.

  2. Open the printer cover.

  3. Press and release the  ink button.

    The print head moves to the  position to indicate which cartridge is low or expended.

    Note: Do not hold the  ink button for more than three seconds, or the printer may start cleaning the print head.

    Caution: Do not move the print head by hand; otherwise, you may damage the printer. And do not touch the flat white cable inside the printer.

  4. Repeat step 3 until the print head moves to the replacement position on the right.

  5. Open the cartridge cover.

  6. Press down each ink cartridge until it clicks into place. (If a cartridge is properly seated already, you may not hear a click.)

    Note: When you installed the new cartridge, you should have removed the yellow tape from the bottom. If you know you removed it, skip to step 7. If you’re not sure, you can pull out the cartridge to check. (Squeeze the tab on the cartridge and lift it straight up.) Remove the tape if necessary, then reinstall the cartridge, pressing it down firmly.

    Remove yellow tapeDon't remove any other tape

    Caution: It’s best not to remove a cartridge unless necessary. Note that if you remove a low or expended ink cartridge, you cannot reinstall and use that cartridge again.

    Warning: If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Keep ink cartridges out of the reach of children.

  7. Close the cartridge cover and push it down until it clicks into place.

  8. Close the printer cover.

  9. Press the  ink button to begin charging the ink. This takes about 1 1/2 minutes.

    When the  power light stops flashing and remains on, ink charging is finished.

    Caution: Never turn off the printer while the  power light is flashing or you’ll waste ink.
Published: October 29, 2009

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page