What can I do about paper feed problems?
Check the following:Paper Does Not Feed Correctly
Paper Ejects Wrinkled
- If paper doesn’t feed, remove it from the tray. Reload it against the right side, then adjust the edge guides. Make sure the paper is not above the edge guides inside the paper cassette.
- If multiple pages feed at once, remove the paper from the tray, fan the edges to separate the sheets, then reload it.
- Load only up to the recommended number of sheets. If you’re printing on both sides of the paper, try loading fewer sheets.
- Use new, smooth, high-quality paper, that is not curled, creased, old, or too thin. Load it printable side down.
- Do not load paper with holes punched in it for insertion in a binder.
- Make sure you adjust the edge guide to match the length of the paper.
- Make sure you adjust the left-edge guide to barely touch the edge of the paper. If it is too tight or snug against the edge of the paper, it may cause misfeeds.
- If paper is wrinkled when it ejects, the paper may be damp or too thin. Load new paper.
- Make sure the paper Type or Media Type setting matches the paper you loaded.
- Use Epson papers to ensure proper saturation and absorption of genuine Epson inks.
- If documents jam in the Automatic Document Feeder, make sure the originals are not creased or folded and do not have tape, staples, or other materials that could obstruct the feeder. Load only up to 30 letter-size sheets (up to 10 for legal-size) at a time.
- For help removing a paper jam, see the solution below for your problem:
Published: September 17, 2009
Thank you for your feedback.
Return to Main FAQs Page