Epson Artisan 810 All-in-One Printer

Selected FAQ

Q:
What should I do if my all-in-one detects only one of two photos placed on the scan bed when I use the Copy/Restore Photos function on the control panel?
A:
Check the following:
  • Make sure the scan bed glass is clean and free of finger prints, smudges, etc. (When cleaning the glass, spray the glass cleaner onto a cloth and then wipe the glass. Never spray glass cleaner directly onto the scan bed.)


  • When copying two photos (up to 4 x 6 inches), place them 1/4 inch (5 mm) apart as shown below.

Published: August 21, 2009

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page