Epson Artisan 810 All-in-One Printer

Selected FAQ

Q:
When I try to make a copy, the all-in-one does not detect the photo placed on the scan bed. What should I do?
A:
Check the following:
  • Make sure the scan bed glass is clean and free of finger prints, smudges, etc. (When cleaning the glass, spray the glass cleaner onto a cloth and then wipe the glass. Never spray glass cleaner directly onto the scan bed.)


  • Make sure the photos are placed on the scan bed correctly. See Place Photos on the Scanner Glass.


  • If you are using the all-in-one’s Copy/Restore Photos function to copy two photos (up to 4 x 6 inches), place them 1/4 inch (5 mm) apart as shown below.

Published: August 21, 2009

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page