Epson Zip-100S (SCSI)

Selected FAQ

Q:
When using my PC, the ASPI drivers load, the drive is found and assigned an ID. However, I cannot access any disks in the drive. I keep getting the message, "drive not valid or disk unreadable."
A:
You will need to follow the SCSI troubleshooting procedures in the "Zipinst.txt" from the Installation disk or from EPSON's Website. Ensure that proper drivers for the SCSI interface card being used are loaded (for example, ASPIDISK.SYS). Also, make sure Guest.ini has a line for remarked as needed for the type of interface (run Guest Info).

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page