LX-300+ Impact Printer

Selected FAQ

I'm printing serial, my baud rate is at 9600, and intermittently the printer will lose data. What can I do to correct this?
If you are using XON/XOFF protocol, the XOFF signal may not reach the printer in time to delay data transmission which would result in an overflow and loss of data. If you can use a DTR setting, change XON/XOFF to DTR. If you must use XON/XOFF, try decreasing the baud rate.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page