Epson Stylus Photo 2200 Ink Jet Printer

Selected FAQ

How do I install my ink cartridge for the first time?
Follow these instructions:

1. Turn the printer on. The ink cartridge holders will move to the installation position.
Lower the printer's output tray and open the top cover.
2. Shake each unopened cartridge up and down 4 or 5 times. Then remove them from their packaging. (Don't shake them after removing from the packaging.
Don't touch the green circuit board on the side of the cartridge.
3. Lift up the cartridge cover, then slide each cartridge into its slot with the green circuit board facing the back of the printer.

Then press each one down until it clicks into place.

4. Close the cartridge cover and printer cover.
5. Press the ink button. The green power and red ink lights flash as your printer charges ink for about 1.5 minutes.

Caution: Don't turn off the printer or interrupt charging, or you'll waste ink. If the power and the ink lights don't turn off after 5 minutes, and the printer isn't making any noise, you can turn it off.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page