Epson Stylus Photo 820 Ink Jet Printer

Selected FAQ

How do I install my ink cartridge for the first time?
First ink cartridge installation takes approximately three minutes. Turn the printer on. The power light will flash and the Maintenance light will come on. The ink cartridge holders will move to the installation position. Unwrap the ink cartridges being careful not to touch the green circuit board on the back of the cartridge, then remove ONLY the yellow tape seal from the black and color ink cartridge. If you accidentally remove anything but the yellow seal you cannot use the cartridge or it will damage the printer. Install the cartridges into the printer. The black ink cartridge goes on the left and the color ink cartridge goes on the right. After the ink cartridges have been inserted into their holders, push down the ink cartridge clamps until they lock in place. Press the Ink Cartridge Replacement button, located on the left side of the printer, to begin charging the ink delivery system. Charging can take up to three minutes and is complete when the power light stops flashing.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page