Epson Stylus Photo 820 Ink Jet Printer

Selected FAQ

Q:
How do I replace an ink cartridge when an ink low or out condition occurs?
A:
Make sure the printer is on but not printing. Press down the Ink Cartridge Replacement button until the print heads move to the center. Pull up the empty ink cartridge clamp all the way. The cartridge rises up from its holder and should be disposed. Unwrap the ink cartridge(s) being careful not to touch the green circuit board on the back of the cartridge, then remove ONLY the yellow tape seal from the black or color ink cartridge. If you accidentally remove anything but the yellow seal you cannot use the cartridge or it will damage the printer. To install the new cartridge, tilt the ink cartridge forward slightly as you lower it into its holder. Hang the tabs at the back of the cartridge on the hooks on the holder clamps. Don't place the cartridge tabs under the hooks on the holder clamp; you may damage the clamp when you close it. Install the ink cartridge and push down on the ink cartridge clamp until it locks in place. Press the Ink Cartridge Replacement button to begin charging the ink delivery system. Charging takes about a minute and is complete when the power light stops flashing and the error light goes out. For more information on installing an ink cartridge please refer to your Start Here poster or your Printer Basics Manual.

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page