Epson Stylus C60 Ink Jet Printer

Selected FAQ

How do I install my ink cartridge for the first time?
First ink cartridge installation takes approximately two minutes. Turn the printer on. The ink cartridge holders will move to the installation position. Unwrap the ink cartridges being careful not to touch the green chip on the back of the cartridge, then remove ONLY the yellow tape seals from the ink cartridges. If you accidently remove anything but the yellow seal you cannot use the cartridge or it will damage the printer. Install the cartridges into the printer. After the ink cartridges have been inserted into their holders, push down the ink cartridge clamps until they lock in place. Press the Ink Cartridge Replacement button, located next to the power button, to begin charging the ink delivery system and close the printer cover. Charging takes about half a minute and is complete when the power light stops flashing. Don't turn off the printer until the power light stops flashing.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page