Epson Stylus Color 600 Ink Jet Printer

Selected FAQ

My printer's control panel locks up after I print a document from Windows. The buttons on the panel do not respond unless I disconnect the parallel printer cable from the back of the printer. What's wrong?
Some computers send an initialize/reset signal during the boot-up process. If the printer cable picks up any noise during this process, the initialize line will not complete its reset phase and cause the control panel to lock. Try booting the computer to Windows, then turn the printer ON using the printer's power switch and try printing again. A defective cable can also cause this situation. Make sure you are using a fully-shielded parallel cable, preferably 6 feet or less.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page