PowerLite 5300 SVGA Projector

Selected FAQ

Why am I getting a NO SIGNAL message?
An image source not connected to the projector is selected, the signal is not being output from the computer, or the signal is not reaching the projector. Make sure the connectors are securely attached to both the projector and the image source. Then check that the image source is selected correctly. If your projector is attached to a Macintosh, make sure that the dip switches on your Macintosh desktop adapter are set correctly. When NO SIGNAL is displayed, you cannot access the source (computer/video) menu. If the image appears on the computer and not on the projector, try pressing the computer or auto button on the projector. If there is still no image, check the computer's resolution and vertical refresh rate. Make sure the resolution you are trying to display is supported. If it is, try changing the refresh rate.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page