High Resolution Document Imager

Selected FAQ

Q:
How do I switch between NTSC and PAL video output?
A:
For video output, the document camera is set at the factory to NTSC mode. Follow the steps below to switch to PAL mode. Before you start, make sure your document camera is plugged in.
1. Make sure the document camera is turned off.
2. Press and hold the Main button on the document camera's control panel.
3. Turn on the document camera.
4. Release the Main button. The document camera will remain in PAL mode, even after turning it off. To switch back to NTSC mode, repeat the same steps.

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page