Epson WorkForce 520 All-in-One Printer

See the instructions below for your connection type.

USB

Follow the software installation instructions on the Start Here sheet.

Note: Before installing the software, make sure the all-in-one is not connected to your computer. (You will be prompted to connect the printer during the installation process.) You must connect the all-in-one to your computer at the correct time to make sure the driver is installed correctly on your computer.

Wireless network

Before you begin, make sure you set up your all-in-one as described on the Start Here sheet. Then do one of the following:

• If this is the first time that you're installing the all-in-one, see Wireless Network Setup.



• If the all-in-one is already on your wireless network and you need to set up additional computers to print to the all-in-one, see Setting Up Additional Computers. You will need to install the software on every computer that will print to your all-in-one.

Wired (Ethernet) network

Before you begin, make sure you set up your all-in-one as described on the Start Here sheet. Then do one of the following:

• If this is the first time that you're installing the all-in-one, see Wired (Ethernet) Network Setup.



• If the all-in-one is already on your network and you need to set up additional computers to print to the all-in-one, see Setting Up Additional Computers. You will need to install the software on every computer that will print to your all-in-one.