Epson WorkForce 630 All-in-One Printer

Selected FAQ

Q:
I replaced an ink cartridge and my product still shows that ink is expended. What should I do?
A:
If you have just installed a new cartridge and you still see an ink related error, the cartridge may not be installed correctly.

Follow the steps below to make sure the cartridge is correctly installed.

Note:
We recommend that you use genuine Epson cartridges and do not refill them. The use of other products may affect your print quality and could result in product damage.

  1. Make sure the product is turned on.


  2. Do one of the following:

    • If you see a message on the product's display screen to install or replace an ink cartridge, press OK.


    • Otherwise, press Setup, select Maintenance, and select Ink Cartridge Replacement.


  3. Lift the scanner.



  4. Open the cartridge cover.



  5. Press down each ink cartridge until it clicks into place. (If a cartridge is properly seated already, you may not hear a click.)



    Note:
    When you installed the new cartridge, you should have removed the yellow tape from the bottom. If you know you removed it, skip to step 6. If you're not sure, you can pull out the cartridge to check. (Squeeze the tab on the cartridge and lift it straight up.) Remove the tape if necessary, then reinstall the cartridge, pressing it down firmly.


    Remove yellow tape

    Caution:
    It's best not to remove a cartridge unless necessary. Note that if you remove a low or expended ink cartridge, you cannot reinstall and use that cartridge again.

    Warning:
    If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Keep ink cartridges out of the reach of children.


  6. Close the cartridge cover and push it down until it clicks into place.



  7. Carefully lower the scanner to begin priming the ink. This takes about 2-1/2 minutes.



    When you see a completion message on the LCD screen, ink priming is finished.

    Note:
    Wait until priming finishes before you turn off your product, or it may prime improperly and use excess ink the next time you turn it on.
Published: August 18, 2010

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page