EX3200 Multimedia Projector

Selected FAQ

What should I do if I see static or noise in the image?
Try the following:

  • If you're using a computer cable longer than 6 feet (1.8 meters), or an extension cable, the image quality may be reduced.

  • Keep your computer and video cables away from the power cord as much as possible to prevent interference.

  • The video signal may be split between the computer and the projector. If you notice a decline in the projected image quality when the image is displayed simultaneously on your notebook computer and the projector, turn off the notebook’s LCD display.

  • Make sure the correct input signal is selected in the Signal menu. See Adjusting Signal Settings.

  • If you are projecting from a composite or S-Video video source, turn on the Progressive setting in the Signal menu. See Adjusting Signal Settings. Turn this setting on also if you are projecting from a component video or HDMI (EX5200/EX7200 only) video source and the signal being sent is interlaced (480i/576i/1080i).

  • If you've used the Keystone adjustment, you may need to decrease the Sharpness setting in the Image menu. See Adjusting the Image.

  • If you're projecting from a computer, make sure its signal is compatible with the projector. See Compatible Video Formats.

  • If you're projecting from a computer, press the Auto button on the remote control to reset the projector's Tracking, Sync, and Position settings.
Published: August 23, 2010

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page