EX7200 Multimedia Projector

Selected FAQ

The remote control doesn't work. What should I do?
Check the following:

  • Point the remote control towards the projector's receiver. Make sure you are within 19.7 feet (6 meters) of the projector and within a 30° horizontal angle and a 15° vertical angle from the projector's front or back receiver.

  • The remote control's batteries may not be installed correctly or may be low on power. To change the batteries, see Replacing the Remote Control Batteries.

  • Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector's infrared receivers. Also, turn off any nearby equipment that emits infrared energy, such as a radiant room heater.

  • If any buttons are held for longer than 30 seconds, the remote enters sleep mode. Release any button that is held to wake the remote.
Published: August 24, 2010

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page