Epson Stylus Pro 7900 Computer to Plate

Selected FAQ

What settings should I have the PCU (plate curing unit) set for?
The PCU is calibrated and set when it comes out of the box. The initial settings should be 190 degrees with a speed of about 1.5. During the setup process you use Thermax strips to confirm that the temperature after going through the PCU is between 150 and 160 degrees. You may need to increase or decrease the temperature control. Different conditions may affect this calibration (such as altitude, ambient temperature and humidity, etc).
Published: September 30, 2011

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page