Epson Stylus Pro 7900 Computer to Plate

Selected FAQ

Can I adjust the printer for feed length and do I need to do this?
Yes, The EFI RIP has an adjustment to compensate for feed length of the Printer because each printer may feed slightly differently. It is HIGHLY recommended that you adjust for this when you first install the printer and the RIP and it should not need to be adjusted again. The adjustment is specfied in the “Preferences” window under the “printer” tab and “media Size” sub-tab as shown below:

The correct process is to enter the target value (430 mm above) and the actual length (430 mm to start). Then, print an alignment sheet that has the included 430 mm line. Measure the line after the printing is complete and then enter the ACTUAL number you measure to the 0.xx mm. Here is the 430 mm line on the alignment sheet (outlined in red):

Published: September 30, 2011

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page