PowerLite 905 XGA 3LCD Projector

Selected FAQ

When the projector is connected to the network with an Ethernet cable, the projector locks up and all the error lights start flashing. What is wrong?
The network port buffer on the projector is being flooded with network traffic. Check your network switch port settings for the following:

  • The PoE (Power over Ethernet) setting may be enabled. The projector does not support this feature. Disable the PoE (Power over Ethernet) feature on the switch ports the projector is connected to.
  • Change the Ethernet switch port settings for the projector connections from Trunk to Access.
  • Multiple VLAN's may be broadcasting traffic to all ports. Allow only the required VLAN traffic to access the projector through the switch ports configured for the projector.

Note: The above settings should be configured on your network and not the projector settings. If you are having difficulty configuring the network settings. Please contact your network administrator for assistance in configuring the network settings.

Published: February 12, 2014

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page