Epson Stylus NX130 All-in-One Printer

Selected FAQ

Q:
What should I do if the printout contains incorrect characters?
A:
Try the following:
  • Make sure the USB cable is a shielded "AB" cable not more than 6.5 feet (2 meters) long.


  • Make sure your product is selected as the active product in your printing program.


  • Turn off the product, check that the cables are securely connected, turn it back on, then try printing again.


  • If you're using a switch box or USB hub with your product, connect the product directly to your computer.


  • Turn the product off and then on again.


  • In Windows, clear any stalled print jobs from the Windows Spooler:


  • Windows 7:
    Click and select Devices and products. Then right-click EPSON NX130 Series, select See what's printing, right-click the stalled print job, and click Cancel and then Yes.

    Windows Vista:
    Click , select Control Panel, and click product under Hardware and Sound. Then right-click EPSON NX130 Series, select Open, right-click the stalled print job, and click Cancel and then Yes.

    Windows XP:
    Click Start and select products and Faxes. (Or open the Control Panel, select products and Other Hardware if necessary, and then products and Faxes). Then right-click EPSON NX130 Series, select Open, right-click the stalled print job, and click Cancel and then Yes.
Published: May 17, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page