PixiePlus™ Control System for Epson Projectors

Selected FAQ

Q:
I can't program PixiePlus. What should I do?
A:
Check the following:

  • Verify that the PixiePlus is in learning mode for programming. The Status LED continually blinks red when the PixiePlus is in learning mode.


  • Ambient light maybe too bright. Shield PixiePlus from ambient light sources and try to re-program.


  • If the buttons appear to program properly but do not control the device, verify each code is correctly learned immediately after it has been programmed. The button blinks rapidly to indicate it is in verification mode. Push the button and the IR emitter emits the corresponding code.
Published: February 2, 2011

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page