Epson Stylus NX230 Small-in-One™ All-in-One Printer

Selected FAQ

Q:
I tried to install the product with a wireless connection on my Mac, but the installation failed. What should I do?
A:
You'll need to set up your software and product again. Do the following:

Disable the Firewall
  1. Select the menu > System Preferences, then click either Security & Privacy or Security.
  2. Select the Firewall tab, then disable the firewall.
  3. If you have other firewall software enabled, you'll also need to disable it. If you don't know how to disable it, contact your firewall provider for help.

    Note: This step is needed to install the product's software and complete the Wi-Fi setup. Remember to enable your firewall software after you complete the Wi-Fi setup.

  4. Go to the next section.
Setup your Product

  1. Complete the setup of your product by following the instructions listed in Article 001850 - Initialize your router and set up your product with a Wi-Fi connection on a Mac
  2. Note: If you were unable to complete any of the steps above, please contact Epson technical support for assistance.
Published: March 15, 2013

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page