Epson WorkForce 435 All-in-One Printer

Selected FAQ

I see the message "Installation Failed" when I install the product's wireless network software. What should I do?
Check the following:

  • Make sure that your wireless router or access point is set to use one of the supported security settings: None, WEP 64, WEP 128, or WPA-PSK (TKIP/AES) WPA2 compliant.

  • If security is enabled for your wireless router or access point, make sure that you entered the correct security key or passphrase.

  • If there are any access restrictions (such as MAC address filtering) set on the wireless router or access point, register the printer's MAC address on the router or access point. Print a Network Status Sheet to obtain the MAC address. Then see your router or access point's documentation for instructions.

  • Disable any settings (such as AP Isolation, Client Isolation, or Privacy Separator) on your wireless router or access point that would prevent wireless devices from communicating with each other.
Published: October 27, 2011

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page