Epson Stylus NX430 Small-in-One™ All-in-One Printer

Selected FAQ

Q:
I tried to install the product with a wireless connection on my Mac, but the installation failed. What should I do?
A:
You'll need to set up your software and product again. Do the following:

Reset your Product's Network Settings

  1. Press the home button on the product's control panel.
  2. Press the arrow buttons to select Setup and press the OK button.
  3. Press the arrow buttons to select Restore Default Settings and press the OK button.
  4. Press the arrow buttons to select Wi-Fi Settings and press the OK button.
  5. Press the arrow buttons to select Yes to set the Wi-Fi settings to default and press the OK button.
  6. The message Defaults restored. will appear to confirm you completed the reset.

  7. Go to the next section. (If you are unable to complete this step, click here.)
Disable the Firewall
  1. Select the menu > System Preferences, then click either Security & Privacy or Security.
  2. Select the Firewall tab, then disable the firewall.
  3. If you have other firewall software enabled, you'll also need to disable it. If you don't know how to disable it, contact your firewall provider for help.

    Note: This step is needed to install the product's software and complete the Wi-Fi setup. Remember to enable your firewall software after you complete the Wi-Fi setup.

  4. Go to the next section. (If you are unable to complete this step, click here.)
Setup your Product

  1. Complete the setup of your product by following the instructions listed in Article 001828 - Initialize your router and set up your product with a Wi-Fi connection on a Mac
  2. Note: If you were unable to complete any of the steps above, please contact Epson technical support for assistance.
Published: March 15, 2013

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page