Epson WorkForce Pro WP-4530 All-in-One Printer

Selected FAQ

Q:
How do I connect my product to my wireless network using the buttons on the control panel?
A:
Follow these steps:
  1. Press the Setup button, if necessary.


  2. Press the arrow buttons and then select Wi-Fi/Network Settings.


  3. Select Wi-Fi Setup.


  4. Select Wi-Fi Setup Wizard.

    Note: If you need to disable the wireless network to set up your product on an Ethernet network, press the arrow buttons and select Disable Wi-Fi instead. Then follow the instructions on the Start Here sheet to set up your product on a wired network and install the necessary software from the product CD. The installer program guides you through network setup.


  5. Select the name of your wireless network or enter the name manually.

    Note: To enter the wireless network name manually, press the arrow buttons and then select Other SSIDs. Use the displayed keypad to enter your network name, as described in the next step.


  6. Enter your wireless password (or network name and then password) using the displayed keypad.

    • Press the arrow buttons to highlight a character or function button, then press OK.


    • To enter a space, select Space and press the OK button.


    • To delete characters, select and press the OK button.


    • When you finish entering characters, select Done and press the OK button.


  7. Confirm the displayed network settings and press the OK button to save them.

    Note: If you need to change a setting, press the Back button.


  8. If you want to print a network setup report, select Yes and press OK. Otherwise, select No.


  9. Press the Copy button to exit.

    The WiFi light should now be on, but not flashing.

    Note: If the WiFi light is off, you may have selected the wrong network name or entered the password incorrectly. Repeat these steps to try again.
Published: September 9, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page