PowerLite S11 SVGA 3LCD Projector

Selected FAQ

Q:
How do I set the password on the projector?
A:
Follow these steps to set a password or change an existing one:

  1. Hold down the Freeze button on the remote control until you see the Password Protect menu. This takes about five seconds.



  2. Press the down arrow to select Password and press Enter.

    You see the prompt Change the password?.


  3. Select Yes and press Enter.


  4. Hold down the Num button on the remote control and use the numeric keypad to enter a four digit password.



    The password displays as **** as you enter it. Then you see the confirmation prompt.


  5. Enter the password again.

    You see the message Password accepted.


  6. Press Esc to return to the Password Protect menu.


  7. Make a note of the password and keep it in a safe place in case you forget it.
Published: July 19, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page