PowerLite Home Cinema 3010e 1080p 3LCD Projector

Selected FAQ

Q:
What should I do if my projected image appears jittery or shaky when viewing video or moving images?
A:
You may need to adjust the 2-2 Pull-down setting. See Sharpness and Picture Quality Settings. This setting can be used only when viewing a 1080p/24Hz signal input through the Component, HDMI 1, or HDMI 2, ports. This setting cannot be used when the Color Mode is set to Auto or with a signal input through the PC port.

If you are viewing video from a device connected to the projector's Video port or from a device connected to the projector's Component, HDMI 1, or HDMI 2 port and the signal being sent is interlaced (480i/576i/1080i), be sure to set the Progressive setting to Film/Auto. See Sharpness and Picture Quality Settings.

Note:
Turning on the Progressive setting converts interlaced signals into progressive signals. Select Video for watching videos captured with a video camera. Set to Off when viewing images with a large amount of movement.

For best results, connect your video equipment to the HDMI 1 or HDMI 2 (High-Definition Multimedia Interface) ports, if possible. If your equipment doesn't support HDMI, connect it to either the Component (for high quality component video) or Video (for composite video).
Published: October 25, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page