PowerLite Home Cinema 5010e 1080p 3LCD Projector

Selected FAQ

Q:
Nothing is projected on the screen or I see the message No Signal. What should I do?
A:
Try the following solutions:
  • Press one of the Source buttons on the remote control, or press the  source button on the projector, to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.


  • Press the Blank button on the remote control to make sure the picture hasnít been turned off temporarily.


  • Check that the power light is on and not flashing, and the lens cover is open.


  • The projector may be in standby (or sleep) mode. If the  power button is lit and the power light is off, press the button to turn the projector back on.

  • Make sure your video equipment is turned on.


  • Make sure your cable(s) are connected correctly. See Connecting the Cables.
Published: December 2, 2011

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page