PowerLite Home Cinema 5010e 1080p 3LCD Projector

Selected FAQ

Nothing is projected on the screen or I see the message No Signal. What should I do?
Try the following solutions:
  • Press one of the Source buttons on the remote control, or press the  source button on the projector, to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.

  • Press the Blank button on the remote control to make sure the picture hasnít been turned off temporarily.

  • Check that the power light is on and not flashing, and the lens cover is open.

  • The projector may be in standby (or sleep) mode. If the  power button is lit and the power light is off, press the button to turn the projector back on.

  • Make sure your video equipment is turned on.

  • Make sure your cable(s) are connected correctly. See Connecting the Cables.
Published: December 2, 2011

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page