BrightLink 480i Interactive XGA 3LCD Projector with Mount

Selected FAQ

My interactive pen doesn't work. It lags, skips, or does not write on the projected image. What should I do?
Try the following solutions:
  • The pens turn off automatically after 20 minutes of inactivity. Slide the switch to turn the pen back on.

  • Make sure you are not covering the black section near the tip of the pen.

  • Make sure nothing is blocking the signal between the pen and the interactive pen receiver on the projector.

  • Try holding the pen at a different angle so that your hand is not blocking the signal.

  • Make sure the cable cover is in place to keep cables from blocking the signal.

  • Make sure the pen battery has enough power. Try replacing the battery.

  • If you are projecting from a computer, make sure the USB cable is connected to the computer and projector.

  • Dim the room lights and turn off any fluorescent lights. Make sure the projection surface and pen receiver are not in direct sunlight or other sources of bright light.

  • If the pen tip is worn out or damaged, you may need to replace it.

  • Make sure the pen receiver on the projector is clean and free from dust.

  • Make sure there is no interference from the infrared remote controls or microphones.

  • Make sure the USB Type-B option on the Extended menu is set to Easy Interactive Function or USB Display/Easy Interactive Function.

  • Make sure the Use Source option on the Extended menu is set to the correct source.

  • Make sure you have calibrated the system. Try recalibrating.
Note: You cannot use both pens at the same time with the built-in interactive toolbar.

Related references
Replacing the Pen Batteries
Replacing the Pen Tips
Installing Easy Interactive Tools
Calibrating the Projector
Using the Pens
Projector Setup Settings - Extended Menu
Published: April 30, 2012

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page