BrightLink 485Wi Interactive WXGA 3LCD Projector with Mount

Selected FAQ

Q:
Can the projector do rear projection?
A:
Yes. You can change the projection mode using the remote control or by changing the Projection setting in the Extended menu. The following modes are available:

  • Front/Upside Down (default setting) flips the image over top-to-bottom to project upside-down from a wall or ceiling mount. This mode should also be used when you mount the projector vertically on a table to create an interactive work surface.


  • Front lets you project from a table in front of a screen.


  • Rear/Upside Down flips the image over top-to-bottom and horizontally to project from the wall or ceiling and behind a translucent screen.


  • Rear flips the image horizontally to project from behind a translucent screen.
Note: The two Rear modes cannot be used with the interactive pens.

Related references
Changing the Projection Mode Using the Remote Control
Changing the Projection Mode Using the Menus
Published: May 1, 2012

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page