802.11b Wireless Print Server

Selected FAQ

Why am I getting the message "Could not complete communicating configuration data" when I send settings to the network adapter?
This might happen when using a dial-up router. Run Command Prompt from the computer in which EpsonNet WinAssist is installed, then enter the following command; Format: >ROUTE_ADD_the IP address of the network adapter_ the IP address of the computer (the under bar represents one space) Example: >ROUTE ADD Also, reinitialize the network adapter, then try again.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page