Epson Stylus C82N Ink Jet Printer

Selected FAQ

Q:
How do I install the driver from the EPSON Stylus C82 CD-ROM in Windows 98 and Windows Me?
A:
Before you start, make sure your printer is set up, connected to your computer, and turned on. Follow these steps to install the printer driver and software:

1. Turn on your computer. (Make sure your printer is still on.) Wait until you see the Add New Hardware Wizard.

Windows 98


Windows Me


2. Put the EPSON CD-ROM in your drive.
3. After a moment, click Next on the Add New Hardware Wizard screen.

If you're running Windows Me, go to step 8.
If you're running Windows 98, continue with step 4.

4. When you see a screen asking 'What do you want Windows to do?', click Next again.



5. You see a screen asking where you want Windows to search.



Click CD-ROM drive. Then click Next.

6. Click Next on the following screen. When you see the screen that says Windows has finished installing your printer software, click Finish.




7. Click Next on each of the four screens that follow.
8. When you see the Default Printer screen, click Finish.



Then wait while the files are copied to your computer.

9. Click Finish when you see the screen saying Windows has finished installing the new hardware device.

10. You see the license agreement. Read the agreement and click Agree to continue installation.

You see the Options Menu. Continue with the instructions below under "Finishing Windows Installation" to complete your software installation.

Finishing Windows Installation

1. When you see the Options Menu screen, make sure you have paper in the printer, then click Print a Test Page to check that your printer is set up correctly.

2. Optionally, click Install EPSON Software Film Factory and follow the on-screen instructions.

3. Click Install Manual and Printer Movies and follow the on-screen directions to install the EPSON Printer Information Center on your desktop.

4. When you're finished, click Exit to close the Options Menu.

5. When you see the EPSON Product Registration screen, register your printer as instructed, then remove your CD-ROM.

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page