Can I connect my product to my wireless network using the buttons on the control panel?
Yes. See the instructions below.
Selecting Wireless Network Settings From the Touch Panel
You can select or
change wireless network settings using your product touch panel.
To install your product on a wireless network, follow the instructions
Start Here sheet and install the necessary software from the
product CD. The installer program guides you through network setup.
Note: Breakdown or repair of this product
may cause loss of fax and network data and settings. Epson is not responsible
for backing up or recovering data and settings during or after the warranty
period. We recommend that you make your own backup or print out your fax and
network data and settings.
- Press the
button, if necessary.
Wi-Fi Setup Wizard.
Note: If you need to disable the wireless network to set up your
product on an Ethernet network, scroll down and select
Disable Wi-Fi instead. Then follow the instructions on the
Start Here sheet to set up your product on a wired network
and install the necessary software from the product CD. The installer program
guides you through network setup.
- Select the name of your wireless network or enter the name
Note: To enter the wireless network name manually, scroll down and
Other SSIDs. Use the displayed keypad to enter your network
name, as described in the next step.
- Enter your wireless password (or network name and then password)
using the displayed keypad.
Note: The network name and password are case sensitive. Be sure to
correctly enter uppercase and lowercase letters, and numeric or special
- Press the touch
screen buttons repeatedly to scroll through characters.
to move the cursor.
1 Symb. to
to delete the previous
Done when youre finished entering your
- Confirm the displayed network settings and press
Proceed to save them.
Note: If you need to change a setting, press the
- If you want to print a network setup report, press one of the
buttons. (Otherwise, press the
- Press the
button to exit.
light should now be on, but not flashing.
Note: If the
light is off, you may have selected the wrong network name or entered the
password incorrectly. Repeat these steps to try again.
Published: March 12, 2013
Return to Main FAQs Page