PowerLite Home Cinema 5020UBe 3D 1080p 3LCD Projector

Selected FAQ

Q:
The projector does not display images from the WirelessHD Transmitter, what should I do?
A:
Try the following solutions:

  • Open the WirelessHD reception monitor and check the strength of the WirelessHD signal. If the signal is weak, you may need to move the transmitter closer to the projector or remove any large objects located between the transmitter and the projector. See WirelessHD Settings.


  • Make sure that your projector is connected to the correct WirelessHD device. It can take up to 30 seconds for a signal to sync and appear after connecting. See WirelessHD Settings.


  • You may need to reset the WirelessHD connection. Turn off both the WirelessHD Transmitter and the projector. Start playback on your video device, then turn on the WirelessHD Transmitter and the projector. Wait 10 seconds, then press the Setup button on the back of the transmitter.


  • Make sure the WirelessHD Transmitter is within 32 feet (10 m) of the projector, isnít obstructed by any large objects, and is not placed on a metal surface..


  • If the green and orange lights on the transmitter are flashing, the unit may be overheating. Make sure the vents on the back of the transmitter are not blocked and that the room temperature does not exceed 95 įF (35 įC).


  • If you are viewing wireless content, make sure that the WiHD light on the transmitter is lit. If it isnít, press the Output button on the remote control or transmitter.
Published: November 30, 2012

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page