PowerLite Home Cinema 3020e 3D 1080p 3LCD Projector

Selected FAQ

Q:
Nothing is projected on the screen or I see the message No Signal. What should I do?
A:
Try the following solutions:
  • Press one of the source buttons on the remote control, or press the  Source button on the projector, to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.


  • Press the Blank button on the remote control to make sure the picture hasn't been turned off temporarily.


  • Check that the power light is on and not flashing, and the lens cover is off.


  • The projector may be in standby (or sleep) mode. If the  power button is lit and the power light is off, press the  power button to turn the projector back on.


  • Make sure your video equipment is turned on.


  • Make sure your cable(s) are connected correctly. See Connecting Video and Computer Equipment.
Published: September 18, 2012

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page