PowerLite Home Cinema 3020e 3D 1080p 3LCD Projector

Selected FAQ

Q:
How do I secure the HMDI cable on the projector?
A:
Fasten the HDMI cable to the projector using the included cable clip. Follow these steps:

  1. Connect the HDMI cable to one of the HDMI ports on the projector.


  2. Insert the end of the cable clip anchor into the cable clip hole near the HDMI port, as shown below.




  3. Place the open cable clip around the HDMI cable, but donít lock it into place.


  4. Slide the cable clip towards the projector and lock the clip onto the HDMI connector.
To remove the cable clip, unlock the clip and disconnect the HDMI cable. Then pinch the side of the cable clip anchor and carefully pull it out of the cable clip hole.

Note: The cable clip works with most conventional round HDMI cables. The cable clip may not work with non-round or thick HDMI cables.
Published: November 30, 2012

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.


Viewed FAQs

Return to Main FAQs Page