PowerLite Home Cinema 3020e 3D 1080p 3LCD Projector

Selected FAQ

Q:
The WirelessHD Transmitter does not communicate with the projector. What is wrong?
A:
You may need to reset the WirelessHD Transmitter. Do the following:

  1. Turn off the WirelessHD Transmitter using the power switch on the side of the transmitter.
  2. Using a pin or paper clip, press and hold the Setup button on the bottom of the transmitter then turn on the power switch on the side of transmitter while still holding the Setup button. Wait 20 seconds, then release the Setup button.
  3. Both the power and the Link lights should be blinking during the reset process.

    Note: If the power and Link lights on the WirelessHD Transmitter do not blink, try performing the reset procedure again.

Published: August 1, 2013

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page