BrightLink 436Wi Interactive WXGA 3LCD Projector
Why isn't there any sound?
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
Adjust the projector's volume settings.
A/V Mute button on the remote control to resume video and audio if they were temporarily stopped.
Source Search or Search button to switch to the correct input source, if necessary.
Check your computer or video source to make sure the volume is turned up and the audio output is set for the correct source.
Check the audio cable connections between the projector and your video source.
If you do not hear sound from an HDMI source, set the connected device to PCM output.
Make sure any connected audio cables are labeled "No Resistance".
If you are using the USB Display function, turn on the
Output audio from the projector setting in the Epson USB Display Settings program on your computer.
If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac supports audio through the HDMI port. If not, you need to connect an audio cable.
If you want to use a connected audio source when the projector is off, set the
Standby Mode option to A/V Standby.
If you turn the projector on immediately after turning it off, the cooling fans may run at high speed momentarily and cause an unexpected noise. This is normal.
Published: May 17, 2013
Return to Main FAQs Page