PowerLite 7800p Multimedia Projector

Selected FAQ

How do I reset the lamp counter to zero after changing the lamp?
You must reset the lamp timer after replacing the lamp to clear the LAMP REPLACE warning message. Follow these steps:

1. Press the Menu button on the remote control (or on the projector's control panel). You see the main menu.

2. Use the pointer button on the remote control (or the arrow buttons on the projector) to highlight About, then press Enter. You see this screen:

3. Select Reset Lamp Timer, then press Enter. You see this prompt:

4. Select Yes, then press Enter.

5. When you're finished, press ESC or Menu to exit.

Note: The lamp usage timer shows 0H until you've used the lamp for at least 10 hours.

Thank you for your feedback.
Was this FAQ helpful?
Yes No  
Please tell us why this FAQ was not helpful.
Note: We are unable to reply to comments submitted here.

Viewed FAQs

Return to Main FAQs Page