PowerLite W16SK 3D 3LCD Dual Projection System

Selected FAQ

Q:
3D content does not display or does not display correctly, what should I do?
A:
If a 3D image does not display correctly, try the following solutions:

  • Press the 2D/3D button on the remote control to switch to 3D mode, if necessary. You can also activate 3D mode by setting the 3D Display setting on the Signal menu to On.
  • Make sure your video device and media are both 3D-compatible. Refer to the documentation that came with your video device for more information.
  • Make sure you are using HDMI cables that support 3D signals. If you are using a splitter, make sure it also supports 3D signals.
  • Make sure you are projecting onto a silver screen (recommended gain: 2.3 to 2.7).
  • Make sure you selected the correct 3D Format setting on the Signal menu. Normally this should be set to Auto, but in some cases you may need to select a different setting to match the 3D signal from your video device.
  • Make sure you are using the supplied 3D glasses or the optional glasses sold by Epson. The glasses supplied and sold by Epson are specifically designed for use with this product. Other passive 3D glasses may not work.
  • Make sure the polarizing filters are attached correctly. The number on each filter should match the number on the projector to which it is attached. See your Setup Guide for instructions.
  • Make sure you are within the 3D viewing range. Also make sure to position the product close enough to the screen.
  • If the other solutions do not not solve the problem, change the Inverse 3D Image setting on the Signal menu. Return the setting to its original value if changing it does not solve the problem.
Published: May 15, 2013

Was this helpful? Yes No Didn't Apply

Viewed FAQs

Return to Main FAQs Page